Loading...

The Camera Control Node allows controlling camera parameters of any Pandoras Box Device such as Cameras and Outputs.

This node can be found under Nodes > Output > Pandoras Box > Camera Control

Node Properties

Camera ID:

Enter here Site and Device ID of the Device to be controlled.

The following Device parameters can be controlled by choosing an input node from the drop-down or entering a numeric value. The check-box next to the respective parameter needs to be ticked to enable it.

- X Pos

- Y Pos

- Z Pos

- Target X

- Target Y

- Target Z

- Z Roll

- FOV

- Aspect

- Lens X

- Lens Y

Silent (Inactive):

Check this box for silent value changes which means that no active values are generated in Pandoras Box.

No Damping:

Check this box to turn off the parameter value smoothing in Pandoras Box.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).